0

Piston Clips

Are new pistons going into your engine, or do the old wrist pin locks need replacing? The locks hold the wrist pin in place in the piston so it doesn't walk out and score the cylinder wall. We stock wire locks and Tru-Arc locks in several sizes for your engine project.

What wrist pin locks do

The wrist pin connects the piston to the connecting rod and, in many designs, can move in the piston's pin bore. The locks sit in a groove at each end of the bore and prevent the pin from sliding sideways out towards the cylinder wall. In this category you'll find, for example, wire locks from JE Pistons and CP Pistons as well as Tru-Arc locks from JE Pistons, and brands such as Mahle, Supertech and Wiseco are also represented. You'll find the pins themselves under wrist pins, and the pistons under pistons.

How to choose the right lock

The lock must match your specific piston, and the correct size depends on the piston's groove, not just the pin diameter. So check:

  • Type: wire lock or Tru-Arc – the piston groove is typically designed for one specific type.
  • Bore size and pin diameter: for example, some CP locks are specified by bore size (.905 in) and pin diameter (23 mm or 21 mm).
  • Wire thickness: for example .073 in, which must match the width of the groove.

As a rule, use new locks every time you assemble, as a lock can lose tension or become deformed when removed. Make sure the lock is fully seated in the groove all the way around and that the gap is positioned as the piston manufacturer specifies. If you buy complete piston sets, locks may already be included – check the contents for the specific part number. If the engine is also getting new piston rings, it makes sense to replace both at the same time.

Frequently asked questions

What is the difference between a wire lock and a Tru-Arc lock?

A wire lock is a bent wire that springs out into the piston groove, while a Tru-Arc lock is a flat retaining ring. Which type you need depends on the groove design of your piston – they typically cannot be interchanged.

Can I reuse the old locks?

This is generally not recommended. The locks can lose tension or become deformed when removed, and a lock that pops out during operation can seriously damage the cylinder wall. New locks at every assembly are the safe solution.

How do I find the right size for my pistons?

Check the piston manufacturer's specifications for your specific piston: lock type, pin diameter, bore size and wire thickness. Product names often state the dimensions, for example bore size in inches and a thickness of .073 in. Always compare with the piston's part number.

View as Grid List
Sort by
Display per page

Lock Ring - 2042968

mhl2042968
Mahle MS 22mm Clip
8,14 € excl. VAT

Lock Ring - 3888765

mhl3888765
Mahle MS 21mm x 1.6mm w/ tang Round Wire Lock Clip
9,43 € excl. VAT

Lock Ring - 4394680

mhl4394680
Mahle MS 22mm x 1.6mm w/ tang Round Wire Lock Clip
9,43 € excl. VAT

Lock Ring - 4399150

mhl4399150
Mahle MS 19mm x 1.6mm Round Wire Lock w/ Tang Clips
10,02 € excl. VAT

Lock Ring - 5871090

mhl5871090
Mahle MS 20mm x 1.6mm w/ tang Round Wire Lock Clip
9,43 € excl. VAT

Lock Ring - 6436901

mhl6436901
Mahle MS .927in x 1.6mm w/ tang Clip
8,72 € excl. VAT